15 North Park Drive , Kaitaia 0410
Contact Us 0800 156 678
Preparation
Major Appliance Cooking
Outdoor Cooking
Heating, Cooling & Air Quality
Appliance Accessories
TV & Projectors
Home & Work Phones
Car Audio
Marine Audio
Cookware
Drinkware
Dining
Personal Care
Gifts & Toys
Travel & Leisure
Monitoring & Security
Office Furniture
Health & Safety
Bedroom Furniture
Dining Room
Office Furniture
Passive Components
Thermal Management
Optoelectronics/LEDs
Electromechanical
SKU: HP9550
$5.80
4 payments of $1.45
6 payments of $0.96
+$3.50 Extra Small Order Shipping Nationwide (+$2 rural)
The low cost way to build prototypes. Each donut is separated from its neighbours by about a 0.5mm gap. This effectively isolates each pad but also makes it easy to bridge solder across to make interconnections. Each board also has `fingers' on opposite ends with a 3.6mm edge pitch. These can be used to connect to and from the board or to a card edge connector. Finally the non- solder side of the board has an alpha- numeric grid printed on it to assist in component identification board layout.
Length | 95mm |
Width | 72mm |
Board type | Doughnut |
PCB hole spacing | 2.54mm |
PCB hole number | 750 |