Folders

These kits differ from MTA305/MTA310 in that the inner seal and retaining ring are one piece. • Comes with dust cover.

Consists of small (outer) bearing 3/4" cone diameter, large (inner) bearing 1-1/4" cone diameter, waterproof rubber seal and seal ret...

Ideal for holding grilles on speaker cabinets. One side is glued or stapled to the box & the other to the grille. The grille then sticks t...

Hookup wire multi-pack containing 2 metres of the 8 standard colours • Suitable for low power applications• 16 metres total Specificat...

Mains rated M205 PCB mount fuse holderFeatures:• Screwdriver opening• Horizontal mounting Specifications: Fuse Type M205 ...

Values ranging from 500 - 500k Ohm Specifications: Trim Pot Type Horizontal Trimpot Scredriver Slot Flat Trimpot Turns 1 Pack ...

Whilst designed for auto horns, this relay is ideal for any high current application i.e. burglar alarms, ignition cutout, transmitters, car s...

This is a plug in base with cable attached.- Suits SY-4068 and SY-4070. Specifications: Cable length 150mm

This is a high performance non-migration interconnection cables utilising 99.96% pure OFC.Features:• 24 carat hard gold plated contacts• 100% ...

This is a high performance non-migration interconnection cables utilising 99.96% pure OFC.Features:• 24 carat hard gold plated contacts• 100% ...

5 stud hubs complete with LM/SL bearings, nuts, dust cap and oil seal.Suits Ford - Galvanised Finish               TTA444

A voltage regulator is an electronic circuit that provides a stable DC voltage independent of the load current, temperature and AC line voltage v...

For use in designs incorporating the use of Smart Cards / IC Cards. Features internal SPST switch triggered by card insertion. ...

You can fit dozens of DIL IC's on this board. 30 holes deep x 50 holes wide, with a link/strip (bus bar) pattern enabling alternate V+ and ear...

Solder lugs for any screw down connection. Features: Length: 17.6mm - ID#1: 4.3mm - ID#2: 2.0mm - PKT 1000

4 Pin Suits Computer Disk Drives Specifications: Pack Quantity 1pc Device Socket Plug or Socket Type I...

Telephone wall plate socket designed to suit standard Australian & New Zealand wall plates. Features:• Rear terminated with IDC fitting• Can ...

Cat5e wall plate socket designed to suit standard Australian & New Zealand wall plates.• Rear terminated with IDC fitting• Can also be ter...

Generally used for splitting switched outputs - like the one on the back of many computers that is used for powering the monitor. Now you can ...

Ideal for connecting a standard powerboard to a UPS etc. SAA approved Specifications: Input Type Standard IEC320 (C13/C14) ...

IEC extension cable (male to female).• SAA aproved Specifications: Input Type Standard IEC320 (C13/C14) Output Type ...

Simply snaps in. Rated at 250V 10A. Specifications: Pack Quantity 1pc Device Socket Plug or Socket Type ...

These Industry standard design RF/EMI filters are designed to reduce line - to - ground (common mode) interference. They accept a standard IEC po...

Features: - Cutout size 47 x 27.5mm. - DPST switch. - M205 size fuse holder Specifications: Pack Quantity 1pc Device ...